A common situation is where a fork steerer has been cut too short or second hand steerer has been purchased and it requires a slight height increase. This post covers an elegant method of setting about the task.
Introduction Ascent is a company based in Singapore who make a bicycle parts. A relatively young company, they have been around on the market for a few years. The wheels on tested were their Polaris with DT 180 hubs and carbon spokes. Ascent have stated their rims are made in China by a third party…
Bicycle wheel balancing is a topic that is often discussed but has not ever been dissected in detail. A lot of professionals balance their wheels and this has filtered down to the amateur ranks wishing to eek out the maximum amount of performance. This post will look at the engineering behind the balancing of bicycle wheels.
A cyclist sent in this Madison Genesis Le Croix titanium bike frame in for a bottom bracket fix. This bike had been through bottom brackets at an alarming rate and the non drive side was visibly damaged. Some further checks were carried out and some issues around stress relief were highlighted. Eventually fixed.
The FUJI Bikes Transonic ONE.1 came in for an engineering roast. This wasn’t the worst that has ever come into Hambini HQ.
This article is a technical discussion of the pros and cons of using grease or retaining compound for installation of bearings and bottom brackets. A general trend in recent times has been a move towards slacker fits. This improves performance and service life.
A Hambini viewer recently enquired about a bottom bracket for his Cannondale TopStone Gravel bike. This bike uses a BB30A83 bottom bracket. A design which is highly unusual, extremely rare and unique to Cannondale. From the frame centerline, the driveside and non drive side apertures have an asymmetrical offset – hence the “A” in BB30A83….
Thanks to Grant from GC Performance YouTube channel for sending in his AbsoluteBLACK Hollowcage OSPW. This has now come in for review. You can find out some other attributes of the AbsoluteBLACK Hollowcage OSPW in the pre-review located here
A high end bike shop in London decided it would be a good idea to fix a customer’s Parlee Z5 bike frame by using Epoxy to glue some Campagnolo bottom bracket cups in to the bike frame. What followed was a customer who was repeatedly going through bottom bracket cups – often in the space…
Introduction Grease is an often talked about but little understood. It can have a significant impact on performance on a bike specifically in the area of transmission frictional losses (watts). This guide covers the practical aspects of using grease as a lubricant and as an assembly aid. Following a number of questions arising from a…
End of content
End of content
No products in the cart.